The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Crank Sensor - Hall

$49.95 $39.95
(You save $10.00)
(No reviews yet) Write a Review
SKU:
SEN_CRK_Hall
Availability:
Available
Shipping:
Calculated at Checkout
Hall Crank Sensor

Here is the Hall sensor I use in my Oxyboxer and Type 4 crank trigger packages. It is dimensional the same as a Honeywell GT101, but has an internal pull-up resistor and offers wider gap tolerance.

 
Specifications:
Operating voltage: 4.75 to 24 volts
Maximum over voltage and reverse voltage: +27 to -25 volts
Maximum output current: 20 mA
Maximum frequency: 15 kHz
Temperature range: -40 to +125 degrees C
Maximum air gap: 5 mm
The trigger wheel must be at least 2 mm wide, the teeth and gaps at least 2 mm wide, and the gaps at least 2 mm deep.

Wiring:
Red - 12v Switched Power
White/Blk - Output Signal
Black - Sensor Ground